Yazar "Kara, Mehmet Emre" seçeneğine göre listele

Listeleniyor 1 - 2 / 2
  • Küçük Resim
    Öğe
    The development of a hybrid cutting model for workpiece temperature distribution via advection heat partition approach
    (Springer Science and Business Media Deutschland GmbH, 2023-04-15) Kara, Mehmet Emre; Kuzu, Ali Taner; Bakkal, Mustafa
    This paper presents a novel hybrid cutting model for the prediction of workpiece temperature distribution during the dry milling process of compacted graphite iron (CGI). The hybrid model consists of an analytical force model based on a mechanistic approach and finite element analysis (FEA) based on the thermal model. The heat generated during the milling process transferred to the workpiece is computed via the advection heat partition model. The workpiece temperature distribution obtained through the heat loads, using as boundary conditions in the FEA, was calculated by means of cutting forces. The developed force and thermal models have been experimentally validated, and good agreement between the measured and calculated results has been observed. The energy and active work calculations show that by doubling the feed during CGI milling, an energy saving of about 10% is achieved despite almost doubling the cutting forces.
  • Küçük Resim
    Öğe
    Investigation of residual stresses induced by milling of compacted graphite iron by x-ray diffraction technique
    (Springer, 2024-04) Kara, Mehmet Emre; Kuzu, Ali Taner; Bakkal, Mustafa
    This study investigates the relationship between residual stresses, cutting parameters, and machining performance in the milling process of compacted graphite iron (CGI). X-ray diffraction (XRD) analysis is employed to measure residual stresses on the cast and milled surfaces, while cutting force modeling is utilized to calculate the tangential force, power, and active work. The results demonstrate that tensile residual stresses are predominant on the milled surfaces, attributed to the both mechanical and thermal loads generated during milling. By analyzing various cutting conditions, it is observed that lower feeds contribute to reduced plastic deformation, resulting in lower residual stress levels. Additionally, higher cutting speeds lead to higher temperatures, but due to the shorter machining time, heat accumulation is limited, resulting in higher residual stresses, especially at low feeds. At high feeds, residual stresses decreased as the cutting speed increased. The interplay between cutting parameters and residual stresses highlights the need for optimizing cutting conditions to enhance fatigue strength in CGI components. These findings provide valuable insights for process optimization and quality control in the milling of CGI materials.