Yazar "Saatlo, Ali Naderi" seçeneğine göre listele
Listeleniyor 1 - 4 / 4
Sayfa Başına Sonuç
Sıralama seçenekleri
Yayın CMOS high-performance UWB active inductor circuit(Institute of Electrical and Electronics Engineers Inc, 2016) Momen, Hadi Ghasemzadeh; Yazgı, Metin; Köprü, Ramazan; Saatlo, Ali NaderiIn order to maximize efficiency of the designed gyrator-based active inductor, advanced circuit techniques are used. Loss and noise are most important features of the AIs, where they should be low enough to have high-performance device. The gyrator-C topology is used to design a new low-loss and low-noise active inductor. The gyrator-C topology is potentially high-Q and all transistors are utilized in common-source configuration to have high impedance in input-output nodes. All transistors are free of body effect. The p-type differential pair input transistors and the feed forward path are employed to decrease noise of the proposed circuit. Additionally, inductance value and quality factor are adjusted by variation bias current which gives to the device tunable capability. HSPICE simulation results are presented to verify the performance of the circuit, where the 180 nm CMOS process and 1.8 V power supply are used. The noise voltage and power dissipation are less than 2.8 nV/ ? Hz and 1.3 mW, respectively.Yayın Design of a new low loss fully CMOS tunable floating active inductor(Springer New York LLC, 2016-12) Momen, Hadi Ghasemzadeh; Yazgı, Metin; Köprü, Ramazan; Saatlo, Ali NaderiIn this paper, a new tunable floating active inductor based on a modified tunable grounded active inductor is proposed. The multi regulated cascade stage is used in the proposed active structure to decrease the parasitic series resistance of active inductor, thus the Q factor enhancement is obtained. Furthermore, the arrangement of this stage leads to the smaller input transistor which determines active inductor’s self-resonance frequency and to be free of body effect which is crucial in sub-micron technology. Symmetrical design strategy has enabled both ports of the proposed floating active inductor to demonstrate the same properties. The Q factor and active inductor value are tuned with bias current and flexible capacitance (varactor), respectively. The self-resonance frequency of floating active inductor (~6.2 GHz) is almost the same as grounded prototype. In addition, the proposed active inductor also shows higher quality factor and inductance value compared to the conventional floating active inductor circuits. To show the performance of suggested circuit, simulations are done by using a 0.18 µm CMOS process, which demonstrates an adjustable quality factor of 10–567 with an inductance value range of 6–284 nH. Total DC power consumption and occupied area are 2 mW and 934.4 µm2, respectively.Yayın Low-loss active inductor with independently adjustable self-resonance frequency and quality factor parameters(Elsevier Science BV, 2017-06) Köprü, Ramazan; Momen, Hadi Ghasemzadeh; Yazgı, Metin; Saatlo, Ali NaderiThis work presents a new low-loss active inductor whose self-resonance frequency and quality factor parameters can be adjusted independently from each other. In order to achieve this property, a new input topology has been employed which consists of cascode structure with a diode connected transistor. Furthermore, the proposed input topology makes the device robust in terms of its performance over variation in process, voltage and temperature. Additionally, RC feedback is used to cancel series-loss resistance of the active inductor, which allows self-resonant enhancement as well. Schematic and post-layout simulation results show the theoretical validity of the design. To validate the design feasibility for process, voltage and temperature changes, Monte Carlo and temperature analysis are done. Suggested structure shows inductor behavior in the frequency range of 0.3–11.3 GHz. Maximum quality factor is obtained as high as 2.1k at 5.9 GHz. Total power consumption is as low as 1 mW with 1.8 V power supply.Yayın A new high performance CMOS active inductor(IEEE, 2016) Momen, Hadi Ghasemzadeh; Yazgı, Metin; Köprü, Ramazan; Saatlo, Ali NaderiA new high-performance active inductor with ability to tune its self-resonance frequency and quality factor without affecting each other is presented in this letter. Using the input transistor of active inductor in cascoding configuration gives this property to designed circuit. Furthermore, the input transistor topology make the device robust in terms of its performance over variation in process and temperature. On the other hand, RC feedback is used to cancel the parasitic components in input node of the active device, which results to improve circuit performance. Schematic and post-layout simulation results shows the theory validity of the design. Monte Carlo and temperature analysis is done to show structure robustness in PVT variation. Inductive behavior frequency range of suggested structure is 0.3-11.4 GHz. Maximum quality factor is obtained as high as 3.7k at 6.3 GHz. Total power consumption is as low as 1mW with 1.8 V power supply.