3 sonuçlar
Arama Sonuçları
Listeleniyor 1 - 3 / 3
Yayın CMOS high-performance UWB active inductor circuit(Institute of Electrical and Electronics Engineers Inc, 2016) Momen, Hadi Ghasemzadeh; Yazgı, Metin; Köprü, Ramazan; Saatlo, Ali NaderiIn order to maximize efficiency of the designed gyrator-based active inductor, advanced circuit techniques are used. Loss and noise are most important features of the AIs, where they should be low enough to have high-performance device. The gyrator-C topology is used to design a new low-loss and low-noise active inductor. The gyrator-C topology is potentially high-Q and all transistors are utilized in common-source configuration to have high impedance in input-output nodes. All transistors are free of body effect. The p-type differential pair input transistors and the feed forward path are employed to decrease noise of the proposed circuit. Additionally, inductance value and quality factor are adjusted by variation bias current which gives to the device tunable capability. HSPICE simulation results are presented to verify the performance of the circuit, where the 180 nm CMOS process and 1.8 V power supply are used. The noise voltage and power dissipation are less than 2.8 nV/ ? Hz and 1.3 mW, respectively.Yayın Designing a new high Q fully CMOS tunable floating active inductor based on modified tunable grounded active inductor(Institute of Electrical and Electronics Engineers Inc, 2015) Momen, Hadi Ghasemzadeh; Yazgı, Metin; Köprü, RamazanA new Tunable Floating Active Inductor (TFAI) based on modified Tunable Grounded Active Inductor (TGAI) is proposed. Multi regulated cascade stage is used in TGAI to boost gain of input impedance and inductor value thus the Q factor enhancement obtained. The arrangement of Multi-Regulated Cascade (MRC) stage is caused the input transistor which determines AI self-resonance frequency to be as small as possible and it is free of body effect which is crucial in sub-micron technology. Compared to traditional CMOS spiral inductors, the active inductor proposed in this paper can substantially improve its equivalent inductance and quality factor. This TFAI was designed using the AMS 0.18 um RF CMOS process, which demonstrates an adjustable quality factor of 10?567 with a 6?284 nH inductance. The Q factor and value of active inductor is adjusted with bias current and flexible capacitance (varactor), respectively. The self-resonance frequency for both grounded and floating AI is about 6.2 GHz. The proposed active inductor also shows wide dynamic range and higher quality factor compared to conventional floating active inductor circuits.Yayın Low-loss active inductor with independently adjustable self-resonance frequency and quality factor parameters(Elsevier Science BV, 2017-06) Köprü, Ramazan; Momen, Hadi Ghasemzadeh; Yazgı, Metin; Saatlo, Ali NaderiThis work presents a new low-loss active inductor whose self-resonance frequency and quality factor parameters can be adjusted independently from each other. In order to achieve this property, a new input topology has been employed which consists of cascode structure with a diode connected transistor. Furthermore, the proposed input topology makes the device robust in terms of its performance over variation in process, voltage and temperature. Additionally, RC feedback is used to cancel series-loss resistance of the active inductor, which allows self-resonant enhancement as well. Schematic and post-layout simulation results show the theoretical validity of the design. To validate the design feasibility for process, voltage and temperature changes, Monte Carlo and temperature analysis are done. Suggested structure shows inductor behavior in the frequency range of 0.3–11.3 GHz. Maximum quality factor is obtained as high as 2.1k at 5.9 GHz. Total power consumption is as low as 1 mW with 1.8 V power supply.
