9 sonuçlar
Arama Sonuçları
Listeleniyor 1 - 9 / 9
Yayın A new late holocene eolianite record from Altinkum Beach, North Cyprus(Scientific technical research council Turkey-Tubitak, 2012-06) Erginal, Ahmet Evren; Güneç Kıyak, Nafiye; Ertek, Topçu AhmetIn this study, we investigated the main depositional characteristics and obtained Optically Stimulated Luminescence (OSL) ages of coastal eolianite on the north coast of Cyprus, where this occurrence had not previously been recorded. Based on EDX/SEM and XRD data and field observations, the studied eolianite that crops out between elevations of 1 m and 14 m a.s.l. is made up predominantly of quartz grains, most of which consist of medium- to fine-grained sand. The rock comprises aragonite, calcite and quartz with lesser amounts of bornite and hematite as accessory minerals. OSL ages indicated that the initial deposition of eolianite sands took place at 1.51 +/- 0.21 ka years ago.Yayın Component resolved OSL dose response and sensitization of various sedimentary quartz samples(Elsevier Ltd, 2007-02) Güneç Kıyak, Nafiye; Polymeris, George S.; Kitis, GeorgeThe structure of the linearly modulated optically stimulated luminescence (LM-OSL) signal was studied for four sedimentary quartz samples, collected from different sites around Istanbul, Turkey. Applying a computerized deconvolution analysis to the LM-OSL curves, at least six individual components of first-order kinetics were identified and photoionization cross-section of each component was evaluated. The OSL dose-response curve of each component for each quartz sample was obtained, showing a remarkable differentiation from component to component. The behavior of a highly dosed sample to successive LM-OSL measurements was also studied showing a stable recuperation signal in the position of the "slow" and "medium" components and high resistance to OSL bleaching of the "slow" component. The individual sensitivity of each component as a function of the activation temperature was obtained. The sensitivity of each component was normalized over the respective sensitivity of the glow-peak at 110 degrees C of quartz in order to investigate the ability of the 110 degrees C glow-peak to act as a correction factor for all components of the LM-OSL curves examined.Yayın Investigating the thermally transferred optically stimulated luminescence source trap in fired geological quartz (vol 62, pg 60, 2014)(Pergamon-Elsevier Science Ltd, 2014-08) Koul, Dileep K.; Patil, Pravinkumar G.; Oniya, Ebenezer O.; Polymeris, George S.[No abstract available]Yayın Thermally assisted OSL from deep traps in Al2O3:C(Pergamon-Elsevier Science Ltd, 2010-03) Polymeris, George S.; Raptis, Spyridoula; Afouxenidis, Dimitrios; Tsirliganis, Nestor C.; Kitis, GeorgeThe present work suggests an alternative experimental method in order to not only measure the signal of the deep traps in Al2O3:C without heating the sample to temperatures greater than 500 degrees C, but also use this signal for high dose level dosimetry purposes as well. This method consists of photo transfer OSL measurements performed at elevated temperatures using the blue LEDs (470 nm, FWHM 20 nm) housed at commercial Riso TL/OSL systems, after the sample was previously heated up to 500 degrees C in order to empty its main TL dosimetric trap. The influence of this procedure on specific features such as glow curve shape and sensitivity of the main TL glow peak was also studied.Yayın On the origin and age of the Ariburnu Beachrock, Gelibolu Peninsula, Turkey(Scientific Technical Research Council Turkey-TUBITAK, 2008-03-13) Erginal, Ahmet Evren; Güneç Kıyak, Nafiye; Bozcu, Mustafa; Ertek, Topçu Ahmet; Güngüneş, Hakan; Sungur, Ali; Türker, GülenThe beachrock formation on the Ariburnu coast situated in the Gelibolu Peninsula has been studied by field observation, thin-section interpretation, physicochemical analyses including ICP-AES and SEM/EDS, and OSL dating. These analyses reveal the presence of different amounts of major (Si, Ca, Mg, K, Fe, Al and Na) and trace elements within the beachrock cement with Si (36.2%) and Ca (32.68%) dominating the overall composition. Beachrocks composed of highly-fractured and friable beds reach a total thickness of 80 cm extending from + 60 cm at the uppermost level down to-1 m at their most seaward extent and grade from conglomerate to lithic arkose in vertical section. The total amount of CaCO(3) ranges between 59.08% and 36% and the cement consists of high-Mg calcite based on EDS analysis. From SEM examination, four main morphologies were identified in cement material: (1) micritic coatings, (2) cryptocrystalline pore-filling cement, (3) meniscus cement and (4) microbial cement and suggest the presence of marine phreatic conditions with the exception of meniscus bridges, which imply that cementation may have been dominated by carbonate-rich meteoric waters at any successive stage of cementation. Five buried beachrock samples under unconsolidated beach sand were sampled for Optically Stimulated Luminescence (OSL) dating and show that the minimum and maximum ages of beachrock are 1.42 +/- 0.20 ka and 2.28 +/- 0.28 ka BP, respectively.Yayın Equivalent dose in quartz from young samples using the SAR protocol and the effect of preheat temperature(Pergamon-Elsevier Science Ltd, 2006-09) Güneç Kıyak, Nafiye; Canel, TimurMajor concerns in the dating of samples younger than a few hundred years by the optically stimulated luminescence (OSL) technique are thermal transfer and partial bleaching. Thermal transfer during preheating enhances the OSL signal due to the charge transfer from thermally sensitive, but light-insensitive, traps to optical centres of quartz and results in an overestimate in equivalent dose, especially for very young samples. In this study, the single-aliquot regenerative-dose protocol is used to obtain values of equivalent dose (D-e) from young samples taken from various environments around Istanbul. Within this framework, we aim to investigate the effect of preheat temperature on equivalent dose from 150 to 300 degrees C, the reproducibility of De measurements for young deposits and the contribution from thermal transfer of charge to the equivalent dose estimation. It was observed that the measured dose is influenced significantly by preheat temperature and the increase in the De is clearly due to thermal transfer of charge from deep thermally sensitive traps to OSL trap during preheating of the samples prior to the main OSL measurements.Yayın Reconstruction of thermally quenched glow curves in quartz(Pergamon-Elsevier Science Ltd, 2012-04) Subedi, Bhagawan; Polymeris, George S.; Tsirliganis, Nestor C.; Pagonis, Vasilis; Kitis, GeorgeThe experimentally measured thermoluminescence (TL) glow curves of quartz samples are influenced by the presence of the thermal quenching effect, which involves a variation of the luminescence efficiency as a function of temperature. The real shape of the thermally unquenched TL glow curves is completely unknown. In the present work an attempt is made to reconstruct these unquenched glow curves from the quenched experimental data, and for two different types of quartz samples. The reconstruction is based on the values of the thermal quenching parameter W (activation energy) and C (a dimensionless constant), which are known from recent experimental work on these two samples. A computerized glow-curve deconvolution (CGCD) analysis was performed twice for both the reconstructed and the experimental TL glow curves. Special attention was paid to check for consistency between the results of these two independent CGCD analyses. The investigation showed that the reconstruction attempt was successful, and it is concluded that the analysis of reconstructed TL glow curves can provide improved values of the kinetic parameters E, s for the glow peaks of quartz. This also leads to a better evaluation of the half-lives of electron trapping levels used for dosimetry and luminescence dating.Yayın Component-resolved thermal stability and recuperation study of the LM-OSL curves of four sedimentary quartz samples(Elsevier Ltd, 2007-09) Kitis, George; Polymeris, George S.; Güneç Kıyak, NafiyeThermal stability as well as recuperation stands among the crucial general characteristics of different OSL components in quartz. Through a series of thermal stability and recuperation experiments, in conjunction with curve fitting studies, a component resolved analysis is carried out, studying these two aspects for the OSL components identified ill quartz samples collected from sites around Istanbul. A thermally unstable ultra-fast component is reported, which is almost totally removed by heating up to 250-280 degrees C. Most slow and medium components show a stability temperature region between 200 and 350 degrees C, whereas the thermal stability of the final slow component is limited Lip to almost 300 degrees C. No detectable recuperation occurs for the first five components reported. The greatest recuperation occurred in the sixth component, despite the fact that it was less than 1%.Yayın LM-OSL thermal activation curves of quartz: Relevance to the thermal activation of the 110 degrees C TL glow-peak(Pergamon-Elsevier Science Ltd, 2008-01) Güneç Kıyak, Nafiye; Polymeris, George S.; Kitis, GeorgeThe thermally activated characteristics (TAC) of the linearly modulated optically stimulated luminescence (LM-OSL) signals of seven quartz samples from different origin were studied relative to the TAC of their respective thermoluminescence (TL) glow-peaks at 110 degrees C. Within the framework of the study the TAC behavior of the LM-OSL was investigated by measuring the OSL signal at room temperature (RT) with the 110 degrees C glow-peak present during OSL measurements, as well as, at 125 degrees C without the glow-peak at 110 degrees C removed by a cut-heat at 180 degrees C prior to OSL measurement. The LM-OSL curves were analyzed into individual components using a computerized deconvolution procedure. It was found that all individual LM-OSL components of each kind of quartz follow the TAC behavior of the respective TL glow-peak at 110 degrees C. The fourth component of the LM-OSL curve, centered at about t(m) = 400 s, appeared when the OSL measurements were performed at RT, whereas it was absent when the OSL measurement were performed at 180 degrees C. It is suggested that this component is closely related with the TL glow-peak at 110 degrees C.
