4 sonuçlar
Arama Sonuçları
Listeleniyor 1 - 4 / 4
Yayın Optical stimulated luminescence dating study of eolianite on the Island of Bozcaada, Turkey: Preliminary results(The Coastal Education and Research Foundation, 2010-07) Güneç Kıyak, Nafiye; Erginal, Ahmet EvrenIn the present paper, eolianite exposed on the south coast of the semiarid island of Bozcaada, Turkey, was investigated on the basis of geomorphologic and petrographic data, and optically stimulated luminescence (OSL) dating results. The eolianite is lithic arenite in composition and contains abundant quartz, calcite, and various lithoclasts amalgamated with micritic calcite, sparitic calcite, and meniscus cements. Within the youngest layers standing at 1-2 m above sea level, the rock contains rhizoliths with or without carbonaceous fills. The OSL ages obtained ranged between 24.21 +/- 1.53 ka and 16.18 +/- 1.70 ka, suggesting that eolianite constitutes an example of low stand deposits coinciding with oxygen isotope stage 2 (OIS-2).Yayın In-homogeneity in the pre-dose sensitization of the 110 degrees C TL peak in various quartz samples: The influence of annealing(Elsevier Science BV, 2012-03-01) Polymeris, George S.; Oniya, Ebenezer O.; Jibiri, Nnamdi N.; Tsirliganis, Nestor C.; Kitis, GeorgeThe pre-dose sensitization effect of the 110 degrees C TL glow-peak of quartz is a basic tool in thermoluminescence and optically stimulated luminescence dating and retrospective dosimetry. In the present work, a homogeneity study was performed on pre-dose sensitization in grains obtained from large quartz crystals samples collected from 10 different origins. The aliquot - to - aliquot scatter of the pre-dose sensitization of the 110 degrees C TL peak within each quartz crystal was monitored. The influence of the annealing on this scattering was also studied. Therefore, the investigation was applied to the un-fired "as is" samples as well as to samples annealed at 900 degrees C for 1 h following cooling to room temperature in air. The results showed that in the case of "as is" quartz the sensitization effect vary strongly within each aliquot of the same quartz sample. This strong variation is removed by both the high temperature annealing as well as heating up to 500 degrees C, involved in the TL measurements. These results are generally discussed in the framework of existing models and applications of the effect.Yayın Investigation of OSL signals from very deep traps in unfired and fired quartz samples(Elsevier Science BV, 2010-03-15) Kitis, George; Güneç Kıyak, Nafiye; Polymeris, George S.; Pagonis, VasilisThis paper presents an attempt to isolate experimentally optically stimulated luminescence (OSL) signals which may originate from very deep traps (VDT) in quartz samples. As VDT we consider those traps which are responsible for TL glow peaks with a peak maximum temperature above a TL readout temperature of 500 C. The basic experimental procedure used to isolate OSL signals from VDT is heating the quartz samples to 500 C immediately before measuring the OSL signal. The study was carried out on eight quartz samples of very different origins; it is found that all eight samples exhibit OSL signals from VDT, and for a wide region of OSL stimulation temperatures. The OSL signal from VDT depends strongly on the type of quartz sample studied and on whether the sample was fired at high temperatures or not. The behavior of the OSL signal from VDT as a function of the stimulation temperature is found to be very different in fired and unfired samples. The thermal activation energy E for the OSL signals from VDT is obtained in both fired and unfired samples. The OSL signal from VDT in quartz samples fired at 800 C for 1 h is very high, and the OSL curves consist of three well-defined components and a fourth slow component which is rather poorly resolved. The dose response of these components is obtained using a computerized deconvolution procedure for the dose region 0.5-300 Gy. The results are of importance for dating of ancient fired ceramics, since OSL signals from VDT could potentially extend appreciably the equivalent dose region toward both lower and higher values.Yayın Thermal quenching of thermoluminescence in quartz samples of various origin(Elsevier Science BV, 2011-03-15) Subedi, Bhagawan; Oniya, Ebenezer O.; Polymeris, George S.; Afouxenidis, Dimitrios; Tsirliganis, Nestor C.; Kitis, GeorgeThe effect of thermal quenching stands among the most important properties in the thermoluminescence (TL) of quartz on which many applications of TL are based. Since the quartz samples used in various applications are all of different origin it is useful to investigate whether the values of the thermal quenching parameters, i.e. the activation energy for thermal quenching W and a parameter C which describes the ratio of non-radiative to radiative luminescence transitions, evaluated mainly in specific quartz samples can be extrapolated to quartz samples of unknown origin as well as to quartz samples which are annealed at high temperatures. In the present work the TL glow curve of a series of un-annealed and annealed natural and synthetic quartz samples were studied as a function of the heating rate between 0.25 K/s and 16 K/s. Using an indirect fitting method it was found that the thermal quenching parameters W and C in most of the quartz samples are very similar to the values accepted in the literature. Furthermore, in some cases the thermal quenching parameters Wand Care not the same for all TL glow-peaks in the same glow-curve. Finally, the strong external treatment of annealing the quartz samples at very high temperature can also influence at least one of the thermal quenching parameters.
