Arama Sonuçları

Listeleniyor 1 - 9 / 9
  • Yayın
    The correlation of fast OSL component with the TL peak at 325 degrees C in quartz of various origins
    (Elsevier Science BV, 2010-02) Kitis, George; Güneç Kıyak, Nafiye; Polymeris, George S.; Tsirliganis, Nestor C.
    The fast component of the optically stimulated luminescence (OSL) signal in quartz is the basic tool for the optical dating. Its relation with the thermoluminescence (TL) glow-peak at about 325 degrees C is well established for naturally irradiated quartz. This relationship is also an important part of a general model for quartz on which many theoretical simulations of various OSL experimental results have been based. In the present work this relationship is systematically investigated in nine quartz samples of different origin. The linearly modulated OSL (LM-OSL) curves of all quartz samples for stimulation time less than 50s consists of two components discriminated easily by a computerized curve deconvolution (CCD) analysis. By comparing the un-bleached to the respective bleached TL glow-curve, it is found that the system of these two fast OSL components is directly related with only a small portion of the electron traps responsible for the TL glow-peaks in the temperature region 200-400 degrees C. By increasing the stimulation times, besides the two fast components, the medium and the slow components are also obtained. The medium and slow components are clearly related with the main body of the electron traps responsible for TL glow-peaks in the same temperature region 200-400 degrees C. Despite their different origin all quartz samples show an appreciable homogeneity concerning the number and time position of the individual components, whereas, the relative TL/OSL intensities vary strongly from sample to sample with the integrated TL intensity being generally much less than the integrated OSL intensity.
  • Yayın
    Component resolved OSL dose response and sensitization of various sedimentary quartz samples
    (Elsevier Ltd, 2007-02) Güneç Kıyak, Nafiye; Polymeris, George S.; Kitis, George
    The structure of the linearly modulated optically stimulated luminescence (LM-OSL) signal was studied for four sedimentary quartz samples, collected from different sites around Istanbul, Turkey. Applying a computerized deconvolution analysis to the LM-OSL curves, at least six individual components of first-order kinetics were identified and photoionization cross-section of each component was evaluated. The OSL dose-response curve of each component for each quartz sample was obtained, showing a remarkable differentiation from component to component. The behavior of a highly dosed sample to successive LM-OSL measurements was also studied showing a stable recuperation signal in the position of the "slow" and "medium" components and high resistance to OSL bleaching of the "slow" component. The individual sensitivity of each component as a function of the activation temperature was obtained. The sensitivity of each component was normalized over the respective sensitivity of the glow-peak at 110 degrees C of quartz in order to investigate the ability of the 110 degrees C glow-peak to act as a correction factor for all components of the LM-OSL curves examined.
  • Yayın
    Thermoluminescence as a probe in bioactivity studies; the case of 58S sol-gel bioactive glass
    (IOP Publishing Ltd, 2011-10-05) Polymeris, George S.; Goudouri, Ourania Menti; Kontonasaki, Eleana; Paraskevopoulos, Konstantinos M.; Tsirliganis, Nestor C.; Kitis, George
    The formation of a carbonated hydroxyapatite (HCAp) layer on the surface of bioactive materials is the main reaction that takes place upon their immersion in physiological fluids. To date, all techniques used for the identification of this HCAp formation are rather time consuming and not well suited to detailed and rapid monitoring of changes in the bioactivity response of the material. The aim of this work is to explore the possibility of using thermoluminescence (TL) for the discrimination between different bioactive responses in the case of the 58S bioactive glass. Results provided strong indications that the 110 degrees C TL peak of quartz can be used effectively in the study of the bioactive behaviour of 58S bioactive glass, since it is unambiguously present in all samples and does not require deconvolution analysis. Furthermore, the intensity of the 110 degrees C TL peak is proven to be very sensitive to the different bioactive responses, identifying the loss of silica which takes place at the first stages of the sequence. The discontinuities of the 110 degrees C TL peak intensity plot versus immersion time at 8 and 1440 min provide experimental indications regarding the timescale for both the beginning of amorphous CaP formation as well as the end of crystalline hydroxyl-apatite formation respectively, while the spike in the sensitization of the 110 degrees C TL peak, which was observed for immersion times ranging between 20 and 40 min, could be an experimental feature indicating the beginning of the crystalline HCAp formation.
  • Yayın
    Relative response of TL and component-resolved OSL to alpha and beta radiations in annealed sedimentary quartz
    (Pergamon-Elsevier Science Ltd, 2011-10) Polymeris, George S.; Afouxenidis, Dimitrios; Raptis, Spyridoula; Liritzis, Ioannis; Tsirliganis, Nestor C.; Kitis, George
    Knowledge of the relative luminescence response to alpha and beta radiation is very important in TL and OSL dating. In the present study the relative alpha to beta response is studied in a sedimentary quartz sample, previously fired at 900 degrees C for 1 h, in the dose region between 1 and 128 Gy, for both thermoluminescence (T) and linearly modulated optically stimulated luminescence (LM - OSL). The LM OSL measurements were performed at room temperature and at 125 degrees C. All OSL signals were deconvolved into their individual components. Comparison of OSL curves after alpha and beta irradiation strongly supports that quartz OSL components follow first order kinetics in both cases. In the case of TL, the relative alpha to beta response is found to be very different for each TL glow-peak, but it does not depend strongly on irradiation dose. In the case of LM OSL measurements, it is found that the relative behaviour of the alpha to beta response is different for three distinct regions, namely the fast OSL component, the region of medium OSL component originating from the TL glow-peak at 110 degrees C when stimulation takes place at room temperature and finally the region of slow OSL component. Following stimulation at ambient temperature, the relative alpha to beta response of all components was not observed to depend significantly on dose, with the value of ratio being 0.03 and a tendency to decrease with increasing dose. However, in the case of measurements performed at 125 degrees C, the relative response of the fast components is much enhanced, and for the remaining components it increases with increasing dose. Special care must be taken to examine the relative alpha to beta response of the fast component at 125 degrees C which contrasts the relative response of the TL peak at ca. 325 degrees C. The implications for the dating of annealed quartz are also briefly discussed.
  • Yayın
    Dissolution and subsequent re-crystallization as zeroing mechanism, thermal properties and component resolved dose response of salt (NaCl) for retrospective dosimetry
    (Pergamon-Elsevier Science Ltd, 2011-09) Polymeris, George S.; Kitis, George; Güneç Kıyak, Nafiye; Sfamba, Ioanna; Subedi, Bhagawan; Pagonis, Vasilis
    In the present study we report dosimetric properties of iodized salt aiming at using it as an accidental luminescent dosimeter. It was found that the very good sensitivity of its main dosimetric peak is strongly affected by thermal treatments. This is also the case for OSL emission. The sensitivity loss due to heating implies that caution should be exercised while applying single aliquot protocols for dose evaluation. The sequence of dissolution and subsequent re-crystallization was established to be an extremely effective zeroing mechanism for the TL signal. The linearity in the dose response was also monitored in the case of dissolved and subsequently re-crystallized salt. In the case of naturally occurring salt, zeroing of the TL signal due to dissolution as well as the linearity of dose response up to doses as large as 100 Gy were found to be very promising features for dating applications.
  • Yayın
    Equivalent dose in quartz from young samples using the SAR protocol and the effect of preheat temperature
    (Pergamon-Elsevier Science Ltd, 2006-09) Güneç Kıyak, Nafiye; Canel, Timur
    Major concerns in the dating of samples younger than a few hundred years by the optically stimulated luminescence (OSL) technique are thermal transfer and partial bleaching. Thermal transfer during preheating enhances the OSL signal due to the charge transfer from thermally sensitive, but light-insensitive, traps to optical centres of quartz and results in an overestimate in equivalent dose, especially for very young samples. In this study, the single-aliquot regenerative-dose protocol is used to obtain values of equivalent dose (D-e) from young samples taken from various environments around Istanbul. Within this framework, we aim to investigate the effect of preheat temperature on equivalent dose from 150 to 300 degrees C, the reproducibility of De measurements for young deposits and the contribution from thermal transfer of charge to the equivalent dose estimation. It was observed that the measured dose is influenced significantly by preheat temperature and the increase in the De is clearly due to thermal transfer of charge from deep thermally sensitive traps to OSL trap during preheating of the samples prior to the main OSL measurements.
  • Yayın
    Component-resolved thermal stability and recuperation study of the LM-OSL curves of four sedimentary quartz samples
    (Elsevier Ltd, 2007-09) Kitis, George; Polymeris, George S.; Güneç Kıyak, Nafiye
    Thermal stability as well as recuperation stands among the crucial general characteristics of different OSL components in quartz. Through a series of thermal stability and recuperation experiments, in conjunction with curve fitting studies, a component resolved analysis is carried out, studying these two aspects for the OSL components identified ill quartz samples collected from sites around Istanbul. A thermally unstable ultra-fast component is reported, which is almost totally removed by heating up to 250-280 degrees C. Most slow and medium components show a stability temperature region between 200 and 350 degrees C, whereas the thermal stability of the final slow component is limited Lip to almost 300 degrees C. No detectable recuperation occurs for the first five components reported. The greatest recuperation occurred in the sixth component, despite the fact that it was less than 1%.
  • Yayın
    TL/OSL properties of crystalline inclusions from heavy, barytes loaded, concrete
    (Pergamon-Elsevier Science Ltd, 2010-03) Güneç Kıyak, Nafiye; Polymeris, George S.; Kitis, George
    In the present work, we report the luminescence data obtained from heavy, barytes loaded, concrete containing many crystalline inclusions, extracted from a shielding block located at CERN. The use of both Thermoluminescence (TL) and Optically Stimulated Luminescence (OSL) signals, resulting from a specific trap at about 200 degrees C, is investigated for retrospective dosimetry purposes. By applying thermal cleaning experiments the TL signal of interest was isolated. Basic TL and OSL properties as thermal and optical stability, repeatability and mainly the linearity of the TL and OSL signals as a function of beta dose were investigated. The implications of all these luminescence properties to retrospective dosimetry are also briefly discussed.
  • Yayın
    Thermoluminescence and optically stimulated luminescence properties of natural barytes
    (Elsevier Ltd, 2010-12) Kitis, George; Güneç Kıyak, Nafiye; Polymeris, George S.
    Heavy, baryte-loaded, concrete is commonly used as radiation shielding material around high energy particle accelerators. Concrete samples received from a shielding block located at CERN cite contain many crystalline inclusions which were identified as barytes by X-ray diffraction analysis and separated by their color, classified as white, orange and green. Basic properties of thermoluminescence (TL) and optically stimulated luminescence (OSL) signals of these barytes samples such as thermal and optical stability, repeatability and mainly the linearity of both their luminescence responses were investigated as a function of beta dose These results are also discussed regarding detailed investigation on the correlation between TL and OSL signals and their implications for retrospective dosimetry