4 sonuçlar
Arama Sonuçları
Listeleniyor 1 - 4 / 4
Yayın Design of optimum nyquist signals based on generalized sampling theory for data communications(IEEE, Piscataway, NJ, United States, 1999-06) Panayırcı, Erdal; Özuğur, Timuçin; Çağlar, HakanA new method is given for the optimal design of bandlimited Nyquist-type signal shapes for data communications, which maximizes its energy in a given time interval. The method is based on the periodically nonuniform sampling (PNS) theory making use of the linear splines. The computation is straightforward, and the constraint for intersymbol interferrence is shown to be easy to include in the problem. A numerical example is given, and performance of the optimal signal shapes is compared with that resulting from the use of previously obtained signal shapes in the literature. It is also concluded that the optimal signal shapes thus obtained are almost immune to small offsets at the sampling instants.Yayın Inductor saturation compensation in three-phase three-wire voltage-source converters via inverse system dynamics(Institute of Electrical and Electronics Engineers Inc., 2022-05-01) Özkan, Ziya; Hava, Ahmet MasumIn three-phase three-wire (3P3W) voltage-source converter (VSC) systems, utilization of filter inductors with deep saturation characteristics is often advantageous due to the improved size, cost, and efficiency. However, with the use of conventional synchronous frame current control methods, the inductor saturation results in significant dynamic performance loss and poor steady-state current waveform quality. This article proposes an inverse dynamic model-based compensation (IDMBC) method to overcome these performance issues. For this purpose, two-phase exact modeling of the 3P3W VSC control system is obtained. Based on the modeling, the inverse system dynamic model of the nonlinear system is obtained and employed such that the nonlinear plant is converted to a virtual linear inductor system for linear current regulators to perform satisfactorily. Further, to control phase currents in the synchronous frame, a two-phase coordinate transformation is proposed. The IDMBC method is tested via dynamic command response and waveform quality simulations and experiments that employ saturable inductors reaching down from full inductance at zero current to 1/9th inductance at full current. The results obtained demonstrate the suitability of the method for 3P3W VSCs employing saturable inductors.Yayın Coherent array imaging using phased subarrays. Part II: Simulations and experimental results(IEEE-INST Electrical Electronics Engineers Inc, 2005-01) Johnson, Jeremy A.; Oralkan, Ömer; Ergün, Arif Sanlı; Demirci, Utkan; Karaman, Mustafa; Khuri-Yakub, Butrus ThomasThe basic principles and theory of phased subarray (PSA) imaging imaging provides the flexibility of reducing I he number of front-end hardware channels between that of classical synthetic aperture (CSA) imaging-which uses only one element per firing event-and full-phased array (FPA,) imaging-which uses all elements for each firing. The performance of PSA generally ranges between that obtained by CSA and FPA using the same array, and depends on the amount of hardware complexity reduction. For the work described in this paper, we performed FPA, CSA, and PSA imaging of a resolution phantom using both simulated and experimental data from a 3-MHz, 3.2-cm, 128-element capacitive micromachined ultrasound transducer (CMUT) array. The simulated system point responses in the spatial and frequency domains are presented as a means of studying the effects of signal bandwidth, reconstruction filter size, and subsampling rate on the PSA system performance. The PSA and FPA sector-scanned images were reconstructed using the wideband experimental data with 80% fractional bandwidth, with seven 32-element subarrays used for PSA imaging. The measurements on the experimental sector images indicate that, at the transmit focal zone, the PSA method provides a 10% improvement in the 6-dB lateral resolution, and the axial point resolution of PSA imaging is identical to that of FPA imaging. The signal-to-noise ratio (SNR) of PSA image was 58.3 dB, 4.9 dB below that of the FPA image, and the contrast-to-noise ratio (CNR) is reduced by 10%. The simulated and experimental test results presented in this paper validate theoretical expectations and illustrate the flexibility of PSA imaging as a way to exchange SNR and frame rate for simplified front-end hardware.Yayın Annular-ring CMUT arrays for forward-looking IVUS: Transducer characterization and imaging(IEEE, 2006-02) Değertekin, Fahrettin Levent; Güldiken, Rasim Oytun; Karaman, MustafaIn this study, a 64-element, 1.15-mm diameter annular-ring capacitive micromachined ultrasonic transducer (CMUT) array was characterized and used for forward-looking intravascular ultrasound (IVUS) imaging tests. The array was manufactured using low-temperature processes suitable for CMOS electronics integration oil a single chip. The measured radiation pattern of a 43 X 140- mu m(2) array element depicts a 40 degrees view angle for forward-looking imaging around a 15-MHz center frequency in agreement with theoretical models. Pulse-echo measurements show a -10-dB fractional bandwidth of 104% around 17 MHz for wire targets 2.5 mm away from the array in vegetable oil. For imaging and SNR measurements, RF A-scan data sets from various targets were collected using all interconnect scheme forming a 32-element array configuration. An experimental point spread function was obtained and compared with simulated and theoretical array responses, showing good agreement. Therefore, this study demonstrates that annular-ring CMUT arrays fabricated with CMOS-compatible processes are capable of forward-looking IVUS imaging, and the developed modeling tools can be used to design improved IVUS imaging arrays.
